Changing the access point’s LAN IP address

This article lists the steps in changing the LAN IP address of the access point.

NOTE:  When changing the LAN IP address of the access point, make sure it uses the same segment as your network.

Step 1:
Access the access point’s web-based setup page.  For instructions, click here.

NOTE:  If you're using a Mac® computer to access the access point's web-based setup page, click here.

Step 2:
On the access point’s web-based setup page, click on the Setup tab and change the IP Address to 192.168.1.x where x is any number from 2 to 253.


 

Step 3:
Click . 

NOTE:  The access point will be reset after applying these settings.

Was this support article useful?

Additional Support Questions?
Search Again