Getting to know the Linksys AC1750 Dual Band Access Point, LAPAC1750

The Linksys AC1750 Dual Band PoE Access Point, LAPAC1750 is the latest Wi-Fi technology to offer a powerful wireless network.  It provides wireless connection to a wired network or extends the wireless coverage of an existing wireless network.  Through the use of this access point, employees can bring their own devices to work, and deploy access point easily with Power over Ethernet (PoE) supported.  With multiple SSID, wireless clients can be divided into different groups to have different access privileges.
 
The Linksys AC1750 Dual Band Access Point, LAPAC1750 can be used in:
  • hotspots operated by an Internet Service Provider (ISP)
  • small offices, home or free hotspots
  • setting up secure wireless networking for wireless clients to access the Internet 
 Features
  • 802.11ac Draft
  • Dual Band PoE Access Point
  • Supports 3x3 MIMO
  • Data Rates:
    • Up to 450 Mbps (2.4 GHz)
    • Up to 1300 Mbps (5 GHz)
  • Supports up to 8 SSID for each band (16 total)
  • AP Isolation
  • Workgroup Bridge Mode
  • Advanced Security and Preventions (802.1x Supplicant, SSID to VLAN Mapping, MAC Access Control, Rogue AP detection)
  • IPv6 Support
  • 1 -10/100/1000 Mbps (PoE)
  • SNMP v1/v2/v3
  • Captive Portal (supported on latest firmware 1.0.07.004)
  • WDS support (supports only LAPN300, LAPN600, LAPAC1200, LAPAC1750 and LAPAC1750PRO devices)
  • Internet Group Management Protocol (IGMP) Snooping
  • Multicast Listener Discovery (MLD Snooping)
  • WPA-Enterprise & WPA2-Enterprise support in Workgroup Bridge
Top panel
 
LED ColorActivityStatus
GreenBlinkingSystem is booting
SolidSystem is normal; no wireless device connected
BlueBlinkingSoftware upgrade in process
SolidSystem is normal; at least 1 wireless device connected
Red
SolidBooting process or update failed; hard reset or service required

Bottom panel
 
  • Power port  - Connect the AC power adapter to this port.  The power adapter uses 12V.
NOTE:  Use only the adapter that came with your access point. 
  • Ethernet port  - Connect a wired network device to this port.  This port supports Power over Ethernet (PoE) with a PoE switch or PoE injector.  LAPAC1750 is powered on from an 802.3at compliant source. 
QUICK TIP:  When both PoE and AC power adapter are connected to the access point, the device will get power from PoE as higher precedence.  Using Cat5e or better cable is highly recommended.
  • Reset button  - Press and hold this button for less than 15 seconds to powercycle the device.  Press and hold up to 25 seconds to reset the device to factory default settings.

Related Video:

Getting to know the Linksys LAPAC2600 (VIDEO)

Getting to know the LAPAC1750PRO BUSINESS AC1750 PRO DUAL-BAND ACCESS POINT (VIDEO)

這篇支援文章有幫助嗎?

尚有其他支援問題?
重新搜尋